Warnings

 

The bottom section of the program window has been re-designed to provide a small panel at the RHS of the status bar, as shown in the figure below.

 

 

AAG_CloudWatcher window

 

This small window is used to provide feedback regarding some anomalies. This information is shown in a short format. To understand the meaning of these messages right-click over this section and the following window is shown:

 

 

Warnings window

 

 

Message

Description

C51 – CCDAutopilot Data File – open/write error

This warning indicates that CCDAutopilot4 data file cannot be created / written to.

 

 

d11 - Data File Path does not exist

The directory corresponding to the path defined for the data file under Setup TAB / Device section has been deleted or its access has been restricted. In a network, it may mean that a network map has not been connected.

d12 - Data File Path could not be created

The program attempted to re-create this path without success. This may be caused by a change of write permission for the drive defined in the path. In a network, it may mean that a network map has not been connected.

d13 - Data cannot be written to data file

This message is shown when Start record button is pressed and there is no-write permission for the directory pointed by the path.

 

 

i21 - Image File Path does not exist

The directory corresponding to the path defined for the image files under Setup TAB / Graphs section has been deleted or its access has been restricted. In a network, it may mean that a network map has not been connected.

i22 - Image File Path could not be created

The program attempted to re-create this path without success. This may be caused by a change of write permission for the drive defined in the path. In a network, it may mean that a network map has not been connected.

i23 - Image Files cannot be created

This warning indicates that the image files are not being created. This may be caused by a lack of write permission for the directory pointed by the path.

i24 - Image Files FreeImage problem

This warning indicates that the image files are not being created because of a problem with FreeImage library. The FreeImage.dll file should be installed in the same directory as AAG_CloudWatcher.exe (default) or in the windows system directory (usually \Windows\System32).

 

 

r31 – COMM Data File– open / read error

This warning indicates the COMM data file does not exist or is corrupted.

 

 

w41 – COMM Data File– open / write error

This warning indicates that COMM data file cannot be created.

w42 – COMM Data too old.

This warning indicates that the COMM Data is older than the timeout value defined in Device section of the Setup TAB.

 

 

NOTE:

 

When warning d13 – Data File cannot be written occurs, the program will automatically stop recording data in the User Data File (Network section / Setup TAB).

 

 

Note that the number of messages may grow as software is revised and other situations are identified.